Unite Solids

(3D only) Used to unite two or more overlapping solids.

Setting	Description
Keep Originals	Determines whether or not the original solids are retained after constructing the solid. None — None of the original solids are retained. All — All of the original solids are retained. First — The first solid selected is retained. Last — The last solid selected is retained.

Setting

Description

Keep Originals

Determines whether or not the original solids are retained after constructing the solid.

None — None of the original solids are retained.
All — All of the original solids are retained.
First — The first solid selected is retained.
Last — The last solid selected is retained.

Key-in: CONSTRUCT UNION

Note: In cases where very large Solids are being united, the results may not be correct if the Solids exceed the Solids Working Area. You should check that the Solids Accuracy is set appropriately for the solids with which you are working. This is controlled by the Solids setting in the Working Areas section of the Advanced Unit Settings Dialog.